Chisel Roll v2 – Now for sale!

The chisel roll that my wife made had garnered some interest and had a number of interested queries including one sale.  She fine tuned it a little based on my feedback, including making the center gap smaller to reduce the chances of fingers grazing sharp edges. I put it to the test last night and I quite like it.

She is making these to order now, so please get in touch if you’d like one!

Chisel Roll version 2

Chisel Roll - Rolled up

7 Comments

  1. Rick Johnson July 1, 2012

    I really like the chisel roll that your wife made you. She did a great job. I would like to buy one done in the wood panel material. How much are they?
    Thanks,
    Rick Johnson

  2. joe mcglynn September 4, 2012

    Very nice!

    I just bought several or I’d be interested myself, I really like these for my chisels and files.

  3. Christopher Robinson September 14, 2012

    Interested in 1 chisel roll v2.

    Thanks –
    Christopher

  4. Badger September 15, 2012

    I think we have one ready to go, I’ll email you offline.

  5. Lydia October 25, 2013

    They look great. How much are they? And how long do they take to make?

  6. Robert Dorgan January 28, 2014

    I am interested in using your “chisel roll” as a long drill bit roll. I have about 10-12 long drill bits ranging from about 15″ to 20″ and need a carrier pouch for them.
    I’m thinking of a roll which would have pockets on one side a flap to tuck over and roll up.
    What material do you make these out of?
    And what would be the cost for a roll made of light canvas, to accommodate 15 ea., 20″ drill bits up to 5/8″ diameter?

  7. Badger January 28, 2014

    Thanks for your interest, I’ll email you with some details.

Leave a Reply

Your email address will not be published. Required fields are marked *

%d bloggers like this: